4
ASSEMBLY INSTRUCTIONS
Water Supply (Cold Water Only):
• Do not draw non-water liquids through the unit. For
use with cold water supply only.
• Water hose must be at least a 1/2 inch diameter.
• Flow rate of water supply must not fall below 2
GPM (gallons per minute).
• Flow rate can be determined by running the water
for one minute into an empty 5-gallon container.
• The water supply temperature must not exceed
104°F (40°C).
CAUTION
• Never use the pressure washer to draw
in water contaminated with solvents (e.g.
paint thinners, gasoline, oil, etc.).
• Dirt in the feed water will damage the unit.
To avoid this risk, we recommend checking
the water lter (located inside the water
inlet; to clean it out see Maintenance sec-
tion on page 11).
• Always prevent debris from being drawn
into the unit by using a clean water source
and an accessory water lter if required.
CAUTION
To prolong the life of the unit, it is recom-
mended to rest the unit 5 minutes after
every 30 minutes of use.
Assembly Time: 5 minutes / Tools Required: Screw Driver
Surface Preparation
Before starting any cleaning task, it is important to inspect the area for objects which could create a hazard.
Remove any objects from the work area which could be tripped over, such as toys or outdoor furniture.
Ensure that all doors and windows are closed tightly.
Step 1
Attach the left wing (D) and the right wing (J) to the pressure washer unit and tighten the screws to secure
the wings to the main unit.
To Next Page
Loading...
