11
Finishing work
Emptying solution
Disposal of solution must by in accordance with the national regulations.
Clean the pad
t Mount or replace the pad and fasten the retainer disk to
it.
Always tighten the retainer disk properly, could cause
damage to the floor when neglected.
t Slowly bring machine into upright position.
t Wipe off the power cord with a moist rag and wrap it
loosely around the machine handle and the cable
mount.
t Empty the spray unit's cleaning solution tank.
t Lay the pad into a cleaning solution for a few hours and
then rinse it off.
The pads may be put into the washing machine and
washed at a max. of 40 °C.
t Air dry all components.
Caution:
Do not dry in a tumbler!
To Next Page
Loading...
