6
Machine installation
insert pad
Check:
• that there there is no point on the pad that has a thickness less than the
minimum thickness of 1 cm.
• that there are no foreign bodies on the pads before putting it into use (e.g.,
sand grains).
• that the pad is mounted.
Could cause damage to floor surface by negligence.
t Stand behind the machine.
t Pull the adjustment lever and slowly lift the guide rod
until it is in the upright position.
t When getting go of the adjustment lever, the guide rod
snaps into place.
Take out the product dispenser before tilting back the machine.
t Tilt back the machine until the handle rests on the floor.
t Screw the retainer disk off of the pad holder.
To Next Page
Loading...
