16
D760M
8 - 9 - 10 MOTOR M2
MOTOR M2 power output, 230 Vac, max. 300 W.
8=CLOSE, 9=COMMON., 10=OPEN.
Notice:
11 - 12 OPEN/CLOSE
OPEN/CLOSE button input (contact normally open); for operating
information see dip-switches 2 and 3 functions. (COMMON=11);
11 - 13 PEDESTRIAN
N.O. PEDESTRIAN button contact input – commands total opening
and closing of motor 1 – governed by dip-switches 2 and 3.
(COMMON=11);
11 - 14 STOP
STOP button input (normally closed contact); this stops the automatic
system. At the next command, the opposite operation to the previous
one is performed (COMMON=9). Bridge the connectors if not used;
15 - 18
SENSITIVE
EDGE
SENSITIVE EDGE input (potential free contact N.C., dip 10 OFF) or
It works during both the opening and closing phases, causing the
temporary stop of the automation and its partial movement reversal
for 20cm, therefore freeing any obstacle (18=COMMON) Note: short-
circuit if not used.
16 - 18
INTERNAL
PHOTOCELLS
PHOTOCELL OR SAFETY DEVICE input INSIDE the automation
(Normally Closed contact); COMMON=18.
When these devices trigger during the opening phase, they tem-
porarily stop the automation until the obstacle has been removed;
during the closing phase they stop the automation and then totally
open it again. Bridge the connectors if not used.
17 - 18
EXTERNAL
PHOTOCELLS
PHOTOCELL OR SAFETY DEVICE input OUTSIDE the automation
(Normally Closed contact); COMMON=18.
Then these devices trigger during the closing phase, they stop the auto-
mation and then totally open it again. Bridge the connectors if not used.
-
19 - 20 ELECTRIC LOCK ELECTRIC LOCK power output 12 Vac max. 15 W;
21 - 22 2
nd
RADIO CH
2nd RADIO CHANNEL output; the output mode can be selected
through Dip Switches 7 - 8;
23 - 24
GATE OPEN
WARNING LIGHT
GATE OPEN WARNING LIGHT output; 24 V ac, max 3W; the light
entire opening and closing manoeuvre and remains on if the gate is
open and off when the gate has closed;
25 - 27 PHOTOCELL TX
24 Vac external transmitting photocell power supply output for safe-
ty device control (connect the external TX photocell only) max. of 2
photocell transmitters;
26 - 27 AUX
24Vac output, 10W for the power supply of photocells, external re-
ceivers, etc.
28 - 29 AERIAL AERIAL input (EARTH=28, SIGNAL=29);
ENGLISH
To Next Page
Loading...
Need help?
General
