14
D760M
WARNINGS
D760M and may therefore not be used for different products!
Important information:
Disconnect the panel from the power supply before opening it.
The D760M control unit has been designed to control an electromechanical gear motor for automating
gates and doors of all kinds.
When designing its products, TAU observes all applicable standards (please see the attached decla-
ration of conformity) but it is of paramount importance that installers strictly observe the same stand-
and doors” category may not install systems under any circumstances.
Whoever ignores such standards shall be held responsible for any damage caused by the
system!
Do not install the unit before you have read all the instructions.
INSTALLATION
Before proceeding, make sure the mechanical components work correctly. Also check that the
gear motor assembly has been installed according to the instructions. Then make sure that
the power consumption of the gear motor is not greater than 3A (otherwise the control panel
may not work properly).
-
Note: it is compulsory to earth the system and to observe the safety regulations that are in
force in each country.
-
ENGLISH
To Next Page
Loading...
Need help?
General
