27
5 TROUBLESHOOTING, CARE AND MAINTENANCE
5.1 General Instructions
⚠ WARNING
+ Do not make any improper changes to the equipment.
⚠ CAUTION
+ Damaged or worn components may aect your safety and the life of the equipment.
Therefore, immediately replace damaged or worn components. In such a case, contact the
contract partner. The equipment must not be used until it has been repaired. If necessary,
use only original spare parts.
࣑ ATTENTION
+ In addition to the instructions and recommendations for maintenance and care given here,
additional service and/or repair work may be necessary; this must only be carried out by
authorised service technicians.
5.2 Faults and Fault Diagnosis
The equipment undergoes regular quality controls during production. Nevertheless, faults or
malfunctions may occur. Frequently, individual parts are responsible for these disturbances, an
exchange is usually sucient. Please refer to the following overview for the most common errors and
how to correct them. If the equipment still does not function properly, contact your contract partner.
Fault Cause Solution
Drive discs wobble or
make noises
Drive pulley is loose Tighten nuts (pay attention to left-hand
/ right-hand thread)
Display does not
work/ does not show
anything
Loose cable
connections
Check cable connections
Device wobbles
Device does not stand
straight
Align feet
Footplates are
creaking
Footplates are loose Tighten up the footplate screws
Creaking noises Screws are loose or too tight Check screws are properly tightened
Squeaking noises on
the guide rails
Guide rails or rollers dirty or
guide rails dry
Clean the guide rails and then lubricate
them with a suitable lubricant
To Next Page
Loading...
