Taurus Z9 - Errors and Error Diagnosis; Maintenance and Service Calendar

Z9
9
2.2 Faults and Troubleshooting
The equipment runs through regular quality controls during production. Nevertheless, errors or
malfunctions on the equipment may occur. Individual parts are often the cause of faults and replacement
is usually sucient. Please use the following overview to see the most common errors and how to repair
them. If the equipment still does not work properly, please contact your contract partner.
Problem Cause Solution
Squeaking & cracking noises
Loose or too tight screw
connection
Check or lubricate screw
connection
Cracking near the
pedal
Loose pedals Tighten pedals
Equipment wobble Equipment is not standing straight Rearrange base
Handlebars/saddle wobble Loose screws Tighten screws
2.3 Maintenance and service calendar
The indoor cycle must be cleaned after every training session with a moist towel (no solvent!) in order
to avoid damage caused by sweat. The following routine work must be executed in the specied time
intervals:
Part Weekly Monthly Annually
Check screws I
Check brake for wear and lubricate
if necessary
I
Display console I
Tighten the pedals I