To Next PageTo Next PageWhy is steering hard on my Taylor-Dunn Utility Vehicle?
Hard steering in your Taylor-Dunn Utility Vehicle can result from a few issues. The lube points in the steering linkage may be dry, or the king pin/ball joint could be damaged. Additionally, low tire pressure can contribute to this problem.
Why is the brake pedal soft or low on my Taylor-Dunn Automobile?
A soft and/or low brake pedal in your Taylor-Dunn Automobile can be attributed to several factors. There might be air in the brake lines, requiring you to bleed the brake system. The master cylinder fluid level could be low, so fill the master cylinder and bleed the system. Lastly, the brake pedal linkage might be out of adjustment, so adjust the linkages.
What to do if brakes are dragging on my Taylor-Dunn Automobile?
If you experience brakes dragging on your Taylor-Dunn Automobile, consider these possible causes: the brake pedal linkage might be out of adjustment, so adjust the linkages; there could be a faulty master cylinder, so inspect it; the brake caliper may be faulty, so inspect the brake calipers; or there might be debris in the brakes, so inspect them.
Why is there a lack of braking power in my Taylor-Dunn Automobile?
Lack of braking power in your Taylor-Dunn Automobile can stem from a few issues. The brake pads might be contaminated, requiring replacement. Alternatively, the brakes could be worn, also necessitating replacement. Lastly, air in the brake lines can cause this issue, so bleed the brake system.
How to fix excessive play in the steering of my Taylor-Dunn Automobile?
If you notice excessive play in the steering of your Taylor-Dunn Automobile, several factors could be responsible. The steering linkages might be damaged or worn, so inspect them. The steering linkages might be loose, so tighten all hardware. The steering wheel could be loose, so inspect the steering wheel nut. Also, loose front spring hardware can cause this, so tighten all hardware.
Why is there noise coming from the front end of my Taylor-Dunn Automobile?
Noise coming from the front end of your Taylor-Dunn Automobile can arise from several sources. Loose wheel nuts can cause noise, so tighten all hardware. Damaged or worn wheel bearings may be the issue, so inspect them. Damaged, worn, or debris in the brakes can also be a culprit, so inspect the brakes. Loose components can cause noise, so tighten all hardware. Finally, damaged or worn suspension mounts can contribute to the noise, so inspect the suspension.
What causes excessive steering play in a Taylor-Dunn B0-254-48 Utility Vehicle?
Excessive steering play in your Taylor-Dunn Utility Vehicle can be caused by worn ball joints, a mis-adjusted or worn steering gear, or loose steering linkage.
Why does the steering pull in one direction on my Taylor-Dunn B0-254-48 Utility Vehicle?
If your Taylor-Dunn Utility Vehicle's steering pulls in one direction, it could be due to a front end that is out of alignment or low tire pressure.
Why does my Taylor-Dunn B0-254-48 Utility Vehicle lack power or operate slowly?
Lack of power or slow operation in your Taylor-Dunn Utility Vehicle can stem from several causes: dragging brakes or parking brakes, worn drive gears, or a front end out of alignment. A fault or overheating in the speed control system could also be responsible. Check if the high/low speed switch is in low or if its wiring is faulty. Additionally, low speed cutback may be due to a maintenance meter trip (if equipped).
How to fix steering that pulls left or right on a Taylor-Dunn Automobile?
If your Taylor-Dunn Automobile steering pulls to the left or right, it may be due to the front end being out of alignment. Realigning the front end should resolve this issue.
General| Brand | Taylor-Dunn |
|---|---|
| Model | B0-254-48 |
| Category | Utility Vehicle |
| Language | English |
