16
Model 142Operating Procedures
Standby
This unit is equipped with a STANDBY feature. If
product is not dispensed for long periods of time (i.e.;
early morning hours), the STANDBY feature will
maintain the hopper and freezing cylinder product at
safe temperatures and prevent product breakdown.
To use the Standby feature, perform the following
steps:
Note: Be sure your hands are clean and sanitized
before performing the following steps.
Step 1
Verify that the hopper is adequately filled with mix and
invert the feed tube.
Figure 29
Step 2
Place the power switch in the AUTO position, and
press the STANDBY button. The button will light,
indicating that the unit is operating as a refrigerator for
product in the hopper and freezing cylinder.
Step 3
To remove the unit from the STANDBY mode, place
the power switch in the AUTO position, and press the
standby button. The light will extinguish, indicating that
the unit has resumed the normal operating mode.
Step 4
When the unit cycles off, remove the hopper cover,
and place the feed tube in its original position.
Figure 30
Step 5
Replace the hopper cover .
IMPORTANT: The STANDBY mode must
not be used in lieu of daily disassembly, cleaning,
and sanitizing.
Closing Procedure
To disassemble the freezer, the following items will be
needed:
S T wo cleaning pails
S Sanitized stainless steel rerun can with lid
S Necessary brushes (provided with freezer)
S Cleaner
S Single service towels
To Next Page
Loading...
