Taylor 150 User Manual (English)

Other manuals for Taylor 150

Questions and Answers:

D
devinmuellerAug 6, 2025
What to do if my Taylor 150 Freezer is not dispensing product?
- J
  Jennifer BeckAug 6, 2025
  If your Taylor Freezer isn't dispensing product, there are several potential causes. First, check if the power switch is in the “OFF” position and switch it to “AUTO”. Ensure the mix hopper has enough mix. If the beater motor overloaded, reset the freezer. Make sure the unit is plugged in and the push-button switch is pressed. Also, check the circuit breaker and fuse, setting the breaker to “ON” or replacing the fuse if necessary, then press the push-button switch. Verify the freezer door is correctly assembled according to the Operator’s Manual. Finally, if you're drawing product too quickly, stop and allow the unit to recover.
N
nclarkAug 12, 2025
Why won't my Taylor 150 operate in AUTO mode?
- S
  shirleyhayesAug 12, 2025
  If your Taylor Freezer won't operate in “AUTO” mode, begin by ensuring the unit is plugged in and the push-button switch is pressed. For T.Q.C. units, momentarily raise the draw switch to activate the refrigeration system. Check the circuit breaker and fuse, setting the breaker to “ON” or replacing the fuse if necessary, and then press the push-button switch. If the beater motor has overloaded, reset the freezer.
S
smithlisaAug 18, 2025
What to do if the product from my Taylor 150 Freezer is too soft?
- J
  James KennedyAug 18, 2025
  If the product from your Taylor Freezer is too soft, first adjust the temperature control, as it may be set too warm. Next, ensure the air tube is correctly installed in the mix inlet hole at the bottom of the mix hopper. Finally, avoid drawing product faster than the freezer's capacity, which is two 4 oz. (113.4 gram) servings in one minute.
A
Abigail FritzAug 25, 2025
How to fix the product if it is too stiff in my Taylor 150?
- C
  Charles PittsAug 25, 2025
  If the product from your Taylor Freezer is too stiff, adjust the temperature control, ensuring it is not set colder than 18 F (?8 C).
L
Leslie PhillipsAug 30, 2025
Why are the freezing cylinder walls scored in my Taylor 150?
- H
  Hannah WeissAug 30, 2025
  If the freezing cylinder walls of your Taylor Freezer are scored, ensure that the front bearing is installed on the freezer door. Additionally, check the alignment of the gear unit or the direct drive and align if necessary.