Need help?Do you have a question about the Taylor 432 and is the answer not in the manual?
Safety and regulatory guidelines for installation and service personnel.
Instructions for preparing the installation area, including environmental and placement considerations.
Guidelines for ensuring proper airflow and preventing overheating of air-cooled machines.
Details on proper grounding, voltage, and power supply requirements for electrical connections.
Instructions on how to check and correct the beater motor rotation direction for proper operation.
Information on the type of refrigerant used (R404A) and safety precautions for handling it.
Details regarding the warranty for the refrigeration compressor and refrigerant usage policies.
Lists and identifies various external parts of the Model 432 freezer with their corresponding part numbers.
Diagram and identification of the individual components that make up the beater door assembly.
Detailed list of parts for the beater door assembly, including descriptions and part numbers.
Illustrates and lists common accessories available for the freezer, such as cleaning brushes and tune-up kits.
Description of the control switch positions (OFF, WASH, AUTO) and their functions.
Instructions on how to reset the freezer after an overload condition using the push-button switch.
Explanation of the display light switch positions (OFF, ON) and its function.
Explains the MIX OUT indicator light, its meaning (hopper empty), and its effect on refrigeration.
Explains the ADD MIX indicator light and its meaning (low product supply).
How to adjust the product viscosity using the adjustment screw and the expected outcome.
Step-by-step instructions for assembling the freezer parts after cleaning.
Detailed procedure for cleaning and sanitizing the freezer components using approved solutions.
Instructions for priming the freezer with fresh mix after sanitizing, preparing it for operation.
List of items required for disassembling the machine for cleaning or storage.
Procedure for draining product from the freezing cylinder before cleaning, with health code considerations.
Instructions for rinsing the freezing cylinder with water after draining product or cleaning solution.
Detailed steps for cleaning the freezer, including solution preparation and machine operation.
Step-by-step guide on how to disassemble the freezer for thorough cleaning and maintenance.
Instructions for cleaning specific parts using brushes and cleaning solution.
Checkpoints to ensure proper cleaning and sanitizing procedures are followed according to health authorities.
Steps to take for troubleshooting high bacteria or coliform counts, focusing on cleaning practices.
Routine checks for parts wear, cleanliness, lubrication, and condenser maintenance.
Precautions for protecting the freezer when the business is closed during winter months to prevent damage.
Addresses issues where the machine fails to dispense product, listing causes and remedies.
Troubleshooting steps for when the machine fails to start or operate in Auto or Wash modes.
Diagnosing and resolving issues related to the compressor not operating during Auto mode.
Identifies causes and solutions for scoring or damage to the freezing cylinder walls.
Troubleshooting excessive leakage detected in the rear drip pan, usually related to seals.
Diagnosing and fixing excessive leakage from the door spout, often due to O-rings or lubrication.
Solutions for problems encountered when trying to remove the drive shaft.
To Next Page
General
