6-8
OPERATING PROCEDURES
Models 358 and 359
Operating Procedures
6
5. Remove the driveshaft drip pan(s) from the front
panel and take to the sink for cleaning.
Note: If the driveshaft drip pan is filled with an
excessive amount of mix, refer to the
Troubleshooting Guide.
6. Thoroughly brush-clean all disassembled parts in the
cleaning solution, making sure all lubricant and mix
film is removed. Take particular care to brush-clean
the draw valve core in the freezer door. Place all the
cleaned parts on a clean, dry surface to air-dry
overnight.
7. Wipe clean all exterior surfaces of the freezer.
To Next Page
Loading...
