EasyManuals Logo

Taylor 390 Operating Instructions

Taylor 390
29 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
11
Model 390 Operating Procedures
Brush Cleaning
Step 1
Prepare a sink with an approved cleaning solution
(example: Kay-5r). USE WARM WATER AND FOL-
LOW THE MANUFACTURER’S SPECIFICATIONS.
(If another approved cleaner is used, dilute according
to label instructions.)
IMPORTANT: Follow label directions, as too
STRONG of a solution can cause parts damage, while
too MILD of a solution will not provide adequate
cleaning.) Make sure all brushes provided with the
freezer are available for brush cleaning.
Step 2
Remove the o-ring and seal from the drive shaft.
Note: To remove o-rings, use a singleservice towel to
grasp theo-ring. Apply pressure inan upwarddirection
until the o-ring pops out of its groove. With the other
hand, push the top of the o-ring forward and it will roll
out of the groove and can be easily removed. If there
is more than one o-ring to be removed, always remove
the rear o-ring first. This will allow the o-ring to slide
over the forward rings without falling into the open
grooves.
Step 3
Remove the draw valve handle and pin, ice buster ,
draw valve, front bearing and gasket from the freezer
door. Remove the scraper blade clips from the scraper
blades. Remove the two o-rings from the draw valve,
and the o-ring and guide bearing from the baf fle
assembly.
Step 4
Return to the freezer with a small amount of cleaning
solution. Brush clean the rear shell bearing at the back
of the freezing cylinder with the black bristle brush.
Step 5
Remove the rear drip pan.
Note: If the drippan isfilled withan excessiveamount
of mix, it is an indication that the drive shaft o-ring, seal
or both should be replaced or properly lubricated.
Step 6
Thoroughly brush clean all disassembled parts in the
cleaning solution making sure all lubricant and mix film
is removed. Place all the cleaned parts on a clean, dry
surfacetoairdry.
Step 7
Wipe clean all exterior surfaces of the freezer.

Other manuals for Taylor 390

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Taylor 390 and is the answer not in the manual?

Taylor 390 Specifications

General IconGeneral
BrandTaylor
Model390
CategoryFreezer
LanguageEnglish

Related product manuals