18
Operating Procedures
Models 702/741/772
Step 3
While the solution is flowing into the freezing cylinder ,
brush clean the hopper. While cleaning the mix hopper ,
take particular care in brushing the mix level sensing
probe on the rear wall of the hopper, the mix inlet hole,
the hopper gasket, and the mix feed tube.
Figure 17
Step 4
Place the control switch in the “WASH” position. This
will cause the sanitizing solution in the freezing
cylinder to agitate. Allow the solution to agitate for five
minutes.
Figure 18
Step 5
Place an empty pail beneath the door spout and raise
the draw arm. Draw off all the sanitizing solution.
Figure 19
Step 6
When the sanitizer stops flowing from the door spout,
lower the draw arm and place the control switch in the
“OFF” position.
Note: You have just sanitized the freezer;
therefore, be sure your hands are sanitized before
continuing these instructions.
Step 7
Stand the mix feed tube in the corner of the mix hopper,
and assemble the hopper gasket.
Figure 20
Repeat Steps 1 through 7 for the other side of the
freezer on the Model 772.
To Next Page
Loading...
Need help?
General
