To Next Page

To Previous Page

Models 702/741/772 Operating Procedures

110616

Rotate the draw valve bracket to the left. Center it into

position by raising the draw arm and placing it into the

slotted groove of the draw valve bracket.

Figure 13

Step 5

Snap the design cap over the end of the door spout.

Figure 14

Step 6

Lay the mix feed tube and the hopper gasket in the

bottom of the mix hopper.

Repeat Steps 1 through 6 for the other side of the

freezer on the Model 772.

Step 7

Install the front drip tray and splash shield under the

door spout(s).

Figure 15

Step 8

Slide the rear drip pan into the hole(s) in the side panel.

Sanitizing

Step 1

Prepare a pail of an approved 100 PPM sanitizing

solution (examples: 2--1/2 gal. [9.5 liters] of Kay--5R

or 2 gal. [7.6 liters] of Stera--SheenR). USE WARM

W ATER AND FOLLOW THE MANUFACTURER’S

SPECIFICATIONS.

Step 2

Pour the sanitizing solution into the hopper and allow

it to flow into the freezing cylinder.

Figure 16

Taylor 702 User Manual

Other manuals for Taylor 702