How to remove a stuck drive shaft from the drive coupling in my Taylor Ice Cream Maker?
If the drive shaft is stuck in the drive coupling, it could be due to mix and lubricant accumulation; regularly brush clean the rear shell bearing area. Rounded corners on the drive shaft or coupling can also cause this, so replace worn components. Finally, a misaligned gear box can be the culprit; re-align it.
What causes scored freezing cylinder walls in my Taylor Ice Cream Maker?
Scored freezing cylinder walls can be caused by a missing or worn front bearing; install or replace it. Broken beater pins (pump style freezers only) can also cause this, so replace the beater assembly, ensuring scraper blades are properly attached over the pins. A bent beater assembly should be replaced. Finally, a misaligned gear box can contribute; re-align it.
Why is product collecting on top of the freezer door of my Taylor Ice Cream Maker?
If product is collecting on top of the freezer door, the top o-ring on the draw valve might be improperly lubricated or worn; lubricate it properly or replace the o-ring.
Safety precautions for installers, including PPE and lockout procedures.
Outlines electrical connection standards, grounding, and safety precautions.
Critical safety warning about personal injury, death, and equipment damage.
Emphasizes reading the manual and using trained personnel for safe operation.
Prohibits operation by untrained personnel and details specific warnings about the door spout and moving parts.
Step-by-step instructions for assembling the freezer components.
Continues assembly steps, covering design caps, drip trays, and splash shields.
Step-by-step guide for sanitizing the freezer components and hopper.
Continues sanitizing procedures, including power switch operation and agitation.
Step-by-step guide for priming the freezer with fresh mix.
Step-by-step guide for cleaning the freezer components.
Continues cleaning procedures, including brush cleaning and exterior surfaces.
Steps to address high bacterial counts, focusing on cleaning and hygiene.
Troubleshooting steps for issues with product dispensing in AUTO mode.
Troubleshooting for product stiffness, softness, and temperature issues.
Troubleshooting for mix temperature, drive shaft, cylinder scoring, and leakage problems.
To Next Page
General
