How to remove a stuck drive shaft from the drive coupling in my Taylor Ice Cream Maker?
If the drive shaft is stuck in the drive coupling, it could be due to mix and lubricant accumulation; regularly brush clean the rear shell bearing area. Rounded corners on the drive shaft or coupling can also cause this, so replace worn components. Finally, a misaligned gear box can be the culprit; re-align it.
What causes scored freezing cylinder walls in my Taylor Ice Cream Maker?
Scored freezing cylinder walls can be caused by a missing or worn front bearing; install or replace it. Broken beater pins (pump style freezers only) can also cause this, so replace the beater assembly, ensuring scraper blades are properly attached over the pins. A bent beater assembly should be replaced. Finally, a misaligned gear box can contribute; re-align it.
Why is product collecting on top of the freezer door of my Taylor Ice Cream Maker?
If product is collecting on top of the freezer door, the top o-ring on the draw valve might be improperly lubricated or worn; lubricate it properly or replace the o-ring.
What to do if the pump won't operate in PUMP mode on my Taylor Ice Cream Maker?
If the pump won't operate in PUMP mode, try pushing the reset button. If that doesn't work, the membrane switch may be defective and need replacement.
Why are the MIX LOW and MIX OUT probes not working on my Taylor Ice Cream Maker?
If the MIX LOW and MIX OUT probes aren't functioning, there might be milkstone build-up in the hopper. Clean the hoppers thoroughly.
What to do if my Taylor Ice Cream Maker is not dispensing product?
If your Taylor Ice Cream Maker isn't dispensing product, several factors could be at play. First, ensure the mix hopper isn't low; if the MIX OUT light is on, add mix. Next, verify the power switch is in the ON position and press the AUTO keypad. If the beater motor is out on reset, allow it to cool, turn the power switch OFF, press the reset button, turn the power switch ON, and press the WASH keypad, checking that the drive shaft turns CLOCKWISE. Then press the AUTO keypad. Also, check the air/mix pump assembly, ensuring it's correctly assembled and properly lubricated. Confirm the spring and poppet are correctly installed on the mix inlet fitting, replacing if necessary. If the mix pump ball crank is broken, replace it. Ensure the pump motor is activated by pushing the reset button and ...
Ensures safe installation practices and adherence to local regulations and PPE requirements.
Covers electrical installation standards, grounding, circuit protection, and wiring requirements.
Crucial safety warnings and instructions for operating, cleaning, and maintaining the machine.
Specific warnings and requirements for electrical grounding, power connections, and cord safety.
Safety guidelines to prevent injury, contamination, and machine damage during operation.
Step-by-step guide for assembling the freezer components, including lubrication.
Detailed steps for cleaning and sanitizing the freezer components and internal parts.
Procedure for priming the freezer with fresh mix after cleaning and sanitizing.
Instructions for rinsing internal parts and performing a general cleaning of the machine.
Detailed instructions for manual brush-cleaning of all parts according to health codes.
Key checkpoints and daily requirements for proper cleaning and sanitizing operations.
Steps to address high bacterial or coliform counts, including thorough cleaning.
Troubleshooting steps for when no product is dispensed with the draw valve open.
Diagnosing and resolving issues related to product consistency (stiff or soft).
Details the warranty periods for various components of the freezer equipment.
Specifies the conditions required for the limited warranty to be valid.
General| Hopper Refrigeration | Yes |
|---|---|
| Refrigerant | R404A |
| Air Cooled | Yes |
| Water Cooled | No |
| Mix Hopper | One |
To Next Page
