Taylor 8752 - Horizon Pump Assembly

22
Models 8752, 8756, 8757Operating Procedures
160518
Figure 16
Step 15
Install the draw valve(s). Slide the two o−rings into the
grooves on the draw valve(s) and
lubricate.
Figure 17
Note: The Models 8756 and 8757 have three draw
valves.
Lubricate the inside of the freezer door spout(s), top
and bottom, and insert the draw valve(s) from the
bottom until the slot in the draw valve(s) comes into
view.
Figure 18
Step 16
Install the adjustable draw handle(s). Slide the
o−ring(s) into the groove(s) on the pivot pin(s) and
lubricate.
Figure 19
Step 17
Slide the fork of the draw handle(s) in the slot of the
draw valve(s). Secure with pivot pin.
Note: The Models 8756 and 8757 have three draw
handles and two pivot pins. Slide the fork of the draw
handle in the slot of the draw valve, starting from the
right. Slide the long pivot pin through the right and
middle draw handles. Secure the left draw handle with
the short pivot pin.