Taylor 8752 - Parts Replacement Schedule

44
Models 8752, 8756, 8757Parts Replacement Schedule
Section 9 Parts Replacement Schedule
PART DESCRIPTION EVERY 3
MONTHS
EVERY 4
MONTHS
EVERY 6
MONTHS
ANNUALLY QTY.
Scraper Blades X 2*
Drive Shaft Seal X 1*
Freezer Door Gasket X 1*
Front Bearing X 1*
Beater Shoes X 2*
Draw Valve O−Ring X 2**
Prime Plug O−Ring X 2*
Pivot Pin O−Ring X 1*
Air/Mix Pump O−Ring X 4*
Liquid Valve Body Check Band X 3*
Mix Inlet Fitting O−Ring X 1*
Pressure Switch Diaphragm X 1*
Design Cap X 1**
White Bristle Brush, 9/16” x 44” Inspect &
Replace if
Necessary
Minimum 1
White Bristle Brush, 1” x 2” Inspect &
Replace if
Necessary
Minimum 1
White Bristle Brush, 3” x 7” Inspect &
Replace if
Necessary
Minimum 1
White Bristle Brush, 3” x 1/2” Inspect & Re-
place if Ne-
cessary
Minimum 1
Small White Bristle Brush Inspect & Re-
place if Ne-
cessary
Minimum 1
Double Ended Brush Inspect &
Replace if
Necessary
Minimum 1
Black Bristle Brush, 1” x 2” Inspect &
Replace if
Necessary
Minimum 1
* Double quantity for Models 8756 and 8757.
** Triple quantity for Models 8756 and 8757.