Taylor 8752 - Parts Replacement Schedule

42
Models 8752, 8756, 8757Troubleshooting Guide
150625
PROBLEM PROBABLE CAUSE REMEDY PAGE
REF.
8. Excessive mix leakage
into the rear drip pan.
a. Worn or missing drive
shaft seal.
a. Install or replace the seal. 19/ 44
b. Improper lubrication of the
drive shaft.
b. Lubricate properly. 19
c. Worn rear shell bearing. c. Contact a service
technician to replace the
rear shell bearing.
− − −
d. The gear box is out of
alignment.
d. Contact a service
technician to align the
gear box.
− − −
9. The drive shaft is stuck in
the gear box coupling.
a. The gear box is out of
alignment.
a. Contact a service
technician to align the
gear box.
− − −
b. Rounded corners on hex
end of drive shaft or gear
coupling.
b. Replace damaged
component.
− − −
10. The freezing cylinder walls
are scored.
a. The scraper blades are
damaged.
a. Replace the scraper
blades.
20
b. The front bearing is
missing or worn on the
freezer door.
b. Install or replace the front
bearing.
21
c. Unit was placed in AUTO
before all sanitizing
solution was removed
from freezing cylinder.
c. Place unit in AUTO only
after priming is complete
and all sanitizing solution
is removed.
31/ 32
d. Broken pins on beater
assembly.
d. Repair or replace the
beater assembly. Be sure
the scraper blades are
properly seated on pins.
20
e. The beater assembly is
bent.
e. Call service technician to
repair or replace the
beater and to correct the
cause of insufficient mix in
the freezing cylinder.