Taylor C712 - Page 14

10
Model C712Operator Parts Identification
140312
X57029-XX Pump A. - Mix Simplified
Figure 3
ITEM DESCRIPTION PART NO.
1-7 PUMP ASSEMBLY - MIX
SIMPLIFIED SOFT SERVE
X57029-14*
1 CYLINDER-PUMP-HOPPER-
SOFT SERVE
057943
2 PIN-RETAINING X55450
3 PISTON 053526
4 O-RING 2-1/8” OD - RED 020051
5 CAP-VALVE 056874-14*
6 GASKET - SIMPLIFIED PUMP
VALVE
053527
7 ADAPTOR - MIX INLET 054825
8 O-RING - 11/16 OD - RED 016132
ITEM DESCRIPTION PART NO.
9 PIN - COTTER 044731
10 SHAFT A.-DRIVE-MIX PUMP X41947
10a CRANK-DRIVE 039235
10b SHAFT-DRIVE 041948
10c O-RING - DRIVE SHAFT 048632
10d O-RING 1-3/4 008904
11 TUBE A.-FEED-LEFT X59808
12 TUBE A.-FEED-RIGHT X59809
13
CLIP-RETAINER-MIX P UMP
044641
14 RING-CHECK-FEED TUBE 056524
15 SLEEVE A.-MIX PUMP *HT X44761
*NOTE: THE STANDARD PUMP IS X57029-14.
OVERRUN CAN BE CHANGED HIGHER OR LOWER
BY SUBSTITUTING THE VALVE BODY CAP. THE
HIGHER THE (-) THE HIGHER THE OVERRUN. YOUR
UNIT INCLUDES 2 OPTIONAL CAPS, 056874-12 AND
056874-16.