Taylor c713 - General Installation Instructions

C713 Operator TrainingC713 Operator Training
C713 Operator TrainingC713 Operator Training
11
The draw handle adjustment knob is intended to slow the product delivery speed.
+
-
Use the screw on the draw handle to
control the speed of product dispensing.
For optimum product quality the rate of
dispensing should be 5 to 7.5 oz (142-213
g) in a 10 sec. draw. If the dispensing rate
is set higher or lower, the risk is poor
product quality and potential damage to the
machine.
To increase the flow rate, turn the screw
clockwise, and counter-clockwise to
decrease the flow rate.
Calibration: Draw Handle