1. Replace scraper blades that are nicked or damaged. Before installing
beater, be certain that scraper blades are properly attached.
2. Check rear shell bearing for signs of wear (excessive mix leakage in
side drip pan) and be certain it is properly cleaned.
3. Using a brush and cloth towel, keep the rear shell bearing and the
female hex drive socket clean and free of lubricant and mix deposits.
4. Dispose of o-rings and seals if they are worn, torn, or fit too loosely, and
replace with new ones.
5. Follow all lubricating procedures as outlined in "Assembly"
6. Check the condenser and filters for accumulation of dirt and lint. A dirty
condenser or filter will reduce the efficiency and capacity of the
machine. The condenser should be cleaned monthly with a soft brush.
The filter should be cleaned weekly.
7. On water cooled units, check the water lines for kinks or leaks. Kinks
can occur when the machine is moved back and forth for cleaning or
maintenance purposes. Deteriorated or cracked water lines should be
replaced only by an authorized Taylor mechanic.
To Next Page
Loading...
