Taylor c713 - Page 22

C713 Operator TrainingC713 Operator Training
20
C713 Operator TrainingC713 Operator Training
Rinsing
Step 1
Pour two gallons (7.6 liters) of cool, clean water into the mix hopper. With the white hopper brush,
scrub the mix hopper and the mix level sensing probe. Using the double ended brush, brush clean
the mix inlet hole.
Note: Do not brush clean the mix inlet hole while the machine is in the WASH mode.
Step 2
With a mix pail beneath the door spout, raise the prime plug and touch the WASH symbol.
Step 3
When a steady stream of rinse water is flowing from the prime plug opening in the bottom of the
freezer door, open the draw valve.
Step 4
Drain all the rinse water from the door spout. Close the draw valve, and touch the WASH symbol,
cancelling the Wash mode.
Repeat rinsing using clean, warm water until the water being discharged is clear.
Repeat these steps for the other side of the machine.