29
C801/C801R/F802/P802/C803/C803R/C804 Operating Procedures
Step 9
Pull the release sheet tight and fold it over the top of
the release sheet bracket.
Figure 30
Step 10
Hold the sheet in place and re-install the retainer
clip.
Figure 31
Step 11
Make sure the platen sheet is firmly positioned
between the front and rear holding brackets. The
platen sheet must fit flat to the bottom and sides of
the platen. Never fold or crease the platen sheet
while handling. It should not be wrinkled or bowed
when properly installed.
Figure 32
The platen sheet helps keep residue from
accumulating between the platens, which adversely
impacts cooking performance.
Step 12
Repeat these steps on the remaining platens to
reinstall the release sheets.
Step 13
After all the platens and the release sheets are
cleaned and reinstalled, wipe the cooking and
staging sides of the grill surface with a damp towel.
This will remove any residue that may have fallen
while cleaning the platens and release sheets.
To Next Page
Loading...
Need help?
General
