6-4
OPERATING PROCEDURES
Model SB25
Operating Procedures
6
4. Place the blender pitcher on the blender base.
(See Figure 6-8.)
Figure 6-8
5. Remove the ice hopper cover. Scoop out as much ice
as possible using a clean, sanitized ice scoop.
(See Figure 6-9.)
WARNING! This machine has many sharp
edges that can cause severe injuries.
• DO NOT put objects or fingers near the shaver
or the pitcher blades.
• USE EXTREME CAUTION when removing
blades that are very sharp.
Failure to follow this instruction may result in
contaminated product or personal injury from blade
contact.
Figure 6-9
6. Reinstall the ice hopper cover. (See Figure 6-10.)
Figure 6-10
7. Press the shave key until all the remaining ice has
been shaved.
8. Remove the blender pitcher and discard the ice into
the back sink. (
See Figure 6-11.)
Figure 6-11
WARNING! Make sure the power switch is in
the OFF position! Failure to follow this instruction may
result in severe personal injury to fingers or hands from
hazardous moving parts.
9. Place the shaver power switch in the OFF position.
To Next Page
Loading...
Need help?
General
