6-6
OPERATING PROCEDURES
Model SB25
Operating Procedures
6
20. Thoroughly flush cleaning/sanitizing solution under
the lip of the ice shaver assembly plastic cover. Make
sure the solution is applied in a complete 360° circle.
(See Figure 6-15.)
Figure 6-15
21. Fill the squeeze bottle with the approved cleaning/
sanitizing solution with an active chlorine concentrate
of 100 PPM to 200 PPM.
22. Repeat steps 17 to 19 using the cleaning/ sanitizing
solution.
23. Thoroughly flush the dispensing area with 4 oz.
(118 ml) of cleaning/sanitizing solution.
(See Figure 6-16.)
Figure 6-16
24. Using the spout brush, brush-clean the dispensing
tubes.
25. If required by your local code, repeat the previous
step using clean water.
26. Repeatedly dip the spout brush into the pail of
cleaning/sanitizing solution and very carefully
brush-clean the shaver assembly blade and
surrounding area.(
See Figure 6-17.)
Figure 6-17
27. Using the squeeze bottle of cleaning/sanitizing
solution, thoroughly flush the shaver assembly blade,
dispensing tubes, and surrounding area.
(See Figure 6-18.)
Figure 6-18
28. If required by your Local code, repeat the previous
two steps using clean water.
29. For machines equipped with the Rinse Station:
Brush-clean the Rinse Station using the squeeze
bottle of cleaning/sanitizing solution and the spout
brush. Pay particular attention to the rinser head and
the drain area. (
See Figure 6-18.)
To Next Page
Loading...
