18
® REGISTERED TRADEMARK OF TAYMOR INDUSTRIES LTD.
PROGRAMMING
CHANGE PROGRAMMING CODE
IMPORTANT: The factory preset programming code is 0-0-0-0 and needs to be changed to a unique
6 digit number before operating the deadbolt.
1. Deadbolt should be in unlocked position.
2. LED indicator flashes “Orange” while in programming mode. LED indicator flashes “Green” twice
with 2 long “Beeps” when programming function is performed correctly. LED indicator light flashes
three times with three “Beeps” when programming function is performed incorrectly.
Note: wait for at least 6 seconds or press
and repeat programming steps if programming error
was committed.
3. Every programming step should be performed in 6 seconds or less.
FUNCTION STEPS
Change
Programming
Code
Enter
Programming
Code
Press
“
4
”
Enter
Programming
Code
To Next Page
Loading...