TBB Energier Apollo CH4.0S User Manual

Energier Apollo User Manual
17
4.1.3 General advice
4.2 Fix Energier Apollo
Ensure that Energier Apollo has the correct DC voltage with your existing battery system.
Install Energier Apollo as close to the batteries as possible reducing the voltage drop on cable for
the better performance of the equipment.
On the AC output side, we recommend connecting the output from Energier Apollo to a suitable
Residual Current Device (RCD) and circuit breaker.
Energier Apollo can be installed either vertically on wall or horizontally on floor. Please follow the
below procedure for wall mounting.
Do not connect the output of this equipment to your AC system at the same time as
any other AC source such as the 230V external mains or a generator.
The neutral of this equipment cannot be connected to the earth. Otherwise the
equipment will be burned or user will get electric shocked in case of reversed
connection on L and N wire.
Model No.
5m -10m
Recommended battery capacity (AH)
Recommended DC fuse
1.5m - 5m
Maximum torque of battery terminals
Preassembled cable length 1.5m
12Nm 12Nm 12Nm 12Nm
CH2.0M
100AH-700AH
150A
100AH-600AH
100A
CH2.0S
100AH-600AH
120A
CH3.0S
100AH-700AH
150A
CH4.0S
Please make sure Energier Apollo turned off before connection. Otherwise, high
voltage can be present.
In order to fully utilize the full capacity of the product, batteries with sufficient capacity and battery
cables with sufficient cross section should be used. See table below.
4.3 Connection of battery cables
Recommended cross section
25mm
2
25mm
2
25mm
2
35mm
2
70mm
2
70mm
2
50mm
2
50mm
2
35mm
2
25mm
2
16mm
2
16mm
2

TBB Energier Apollo CH4.0S Specifications

General

Brand	TBB
Model	Energier Apollo CH4.0S
Category	Inverter
Language	English