TBS Installation Manual – 2D IRON & 3D AIR
TBS 2D IRON 3D AIR Mounting and Installation Guideline • TBS-056-057 • Rev 09-2023 page 10 of 21
4.3.3 Heavy Duty Box (IP65)
The following equipment and tools are required for mounting the heavy duty variant.
• Four ø4-5mm screws and fitting raw plugs suitable for the wall material (not included)
• One screwdriver appropriate to drive the above screws
• One drill with a drill bit of an appropriate diameter for the above raw plugs
• One Allen wrench (size 3) screwdriver to open the terminal
The recommended mounting height of the terminal is 1.16 m, measured from the floor to the lower
screw holes of the back cover.
To Next Page
Loading...