tbs electronics 2D IRON - 3 Declarations of Conformity; European Union (CE) Regulatory Notices; USA (FCC) Regulatory Notices; Canada (IC) Regulatory Notices

TBS Installation Manual – 2D IRON & 3D AIR
TBS 2D IRON 3D AIR Mounting and Installation Guideline • TBS-056-057 • Rev 09-2023 page 5 of 21
3 Declarations of Conformity
3.1 European Union (CE) regulatory notices
Products bearing the CE marking comply with one or more of the following EU Directives as may be
applicable:
• EMC directive 2014/30/EU
• REACH Directive 1907/2006
• RoHS Directive 2015/863/EU
Compliance with these directives is assessed using applicable European Harmonized Standards.
2D IRON and 3D AIR are intended to be used for professional application only (buildings, airport...).
They are an EMC Class A product according to EMC directive 2014/30/EU. The product may cause
interference if used in residential areas. Such use must be avoided unless the user takes special
measures to reduce electromagnetic emissions to prevent interference to the reception of radio and
television broadcast. The full Declaration of Conformity is available on demand to your reseller. Please,
provide him the product model name or its Regulatory Model Number (Model on the label).
3.2 USA (FCC) regulatory notices
The 2D IRON and 3D AIR comply with FCC 47 CFR Part 15B. Operation is subject to the following two
conditions: (1) the device may not cause harmful interference, and (2) the device must accept any
interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment. Responsible Party:
Touchless Biometric Systems AG
Rietbrunnen 2
8808 Pfaeffikon
Switzerland
NOTE:
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to FCC 47 CFR Part 15B of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
3.3 Canada (IC) regulatory notices
WARNING TO USERS IN CANADA / ATTENTION POUR LES UTILISATEURS AU CANADA
The 2D IRON and 3D AIR comply with ICES 003: 2017 and 2016. Operation is subject to the following
two conditions: (1) the device may not cause interference, and (2) the device must accept any
interference, including interference that may cause undesired operation of the device.
Le 2D IRON et le 3D AIR sont conformes à la norme ICES 003 : 2017 et 2016. L’exploitation est
autorisée aux deux conditions suivantes: (1) l’appareil ne doit pas produire de brouillage, et 2)
l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.