50
TROUBLESHOOTING
You are not getting any sound through the G-Force when you bypass it.
- You selected Killdry ON, in the I/O Setup, Audio menu.
You press Power switch, but there is no reaction.
- The power switch on the rear panel is switched off.
You can not turn the power off.
- Press and hold the Power switch for 3 seconds, then release to power off
No sound through the G-Force.
- You are using Analog input, but the input selector in I/O Setup, Audio menu is set to Digital.
The sound is phasing with your direct signal.
- You are running the G-Force in a parallel setup, but the killdry function in I/O Setup, Audio menu is set to Off.
Right input meter is not showing any signal.
- You selected L-Only in the I/O Setup, Audio menu.
Effects only in the Left Output
- You are only using Left input, but the Input selector in I/O Setup is set to Stereo.
Your Expression pedal does not work properly
- Be sure the G-Force is set to the correct pedal type and the pedal is calibrated correctly in the Utility menu.
To Next Page
Loading...
