Introduction
VoiceLive 3 – Reference manual (2014-03-29) 13
4. Home button
Use the Home button to return
to the “top level” interface. The
screen will show Preset Num-
ber and any effects associated
with the current layer.
5. Control knob
Use the Control knob to move
through Presets and scrolls up/
down when in an edit screen.
When in the “Home” screen,
press to add or remove the
current Preset from the Favor-
ite genre.
6. Vocal button
Use the Vocal button to enter
the Vocal edit screens. This is
where you can make changes
to the vocal effects for the cur-
rent Preset. For more informa-
tion, see “Editing the Vocal layer”.
7. Guitar button
Use the Guitar button to en-
ter Guitar edit screens. This is
where you can make changes
to any of the guitar effects for
the current Preset. For more in-
formation, see “Editing the Guitar layer”.
8. Looper button
Use the Looper button to enter
the Loop options screen. Here
you can control several general
Loop options.
9. Mix knobs
From the Home screen, turn-
ing any mix knob enters the
Mix screens (Main, Head-
phones and Effects).
Within an Edit page, the mix knobs adjust values
and settings.
10. Arrow buttons
When you are on the Home
screen, you can use the Ar-
row buttons to move through
Presets.
When you are on an Edit screen, use the Arrow
buttons to move between pages.
11. NP LED
The NP LED lights when Nat-
uralPlay (chord) information is
received via Guitar, MIDI, Aux
or RoomSense.
12. Level LEDs
The Level LEDs show input lev-
el for the Mic input. The red
LED also lights if any other in-
put – for example your guitar –
clips (too much signal).
To Next Page
Loading...
Need help?
General
