Setup
VoiceLive 3 – Reference manual (2014-03-29) 108
System tab
Contrast parameter
Use the Contrast parameter to set VoiceLive 3’s
display contrast.
Depending on the angle that you view the screen
from, different contrast settings may make things
easier to read.
Global Preset parameter
Use the Global Preset parameter to define a
Global Preset that should be used as a start-
ing point/reference for all Presets where effect
blocks are set to Global ON.
Usually, you will find the Global setting at the
bottom of every effect block edit screen. As
soon as you change Global from OFF to ON
within an effect block, the corresponding effect
settings from your the Global Preset will be ap-
plied to that effect.
For more information, see “Important: The link
between the Global Preset and other Presets
goes both ways”.
Global NatPlay Source parameter
Use the Global NatPlay Source parameter to de-
fine a global signal source for the NaturalPlay
feature. Use this parameter if you want to make
sure that only audio or control data from a spe-
cific source is used to determine key/scale. For
more information, see “What is NaturalPlay?”.
Parameter settings:
– Auto: VoiceLive3 “listens” to any audio or con-
trol data coming from the Guitar input / MIDI
or USB port / Aux input / RoomSense micro-
phones to determine the key/scale that should
guide Harmony voices and HardTune.
– Guitar: Audio received at the Guitar input is
used to determine key/scale.
– MIDI: MIDI note messages received at the
MIDI IN jack are used to determine key/scale.
– Aux: Audio received at the Aux input input is
used to determine key/scale.
– RoomSense: Audio received by the built-in
RoomSense microphones is used to deter-
mine key/scale.
To Next Page
Loading...
Need help?
General
