TC-Helicon VoiceLive 3 Reference Manual

VoiceLive3 overview
VoiceLive 3 – Reference manual (2014-03-29) 27
Stereo vocals and a guitar amplifier
This setup is great if you have got a guitar amp
and want to send VoiceLive3’s guitar sounds to
that amp instead of to the PA.
You may want to make a quick adjustment to the
guitar output if you are connected to an amp.
It might be desirable to turn off VoiceLive 3’s
speaker simulations while preserving all of the
other guitar effects. This will allow the “charac-
ter” of your amp to stay the same from Preset to
Preset.
Follow the Stereo PA connection instructions to
change your output mode to Stereo.
Turning speaker simulation off
– Press Setup.
– Use the < or > Arrow buttons to move to the
Guitar tab.
– Use the Control Knob to move the selection
bar until Speaker Sim Enable is highlighted.
– Turn the Mix Knob directly below the dis-
play until the setting for Speaker Sim Enable
changes from On to Off.
– Press Home to exit.
Turning speaker simulation off
For Mono vocals via the PA and guitar sounds
via a guitar amplifier, follow the diagram above,
but connect only the Left XLR output from Voice-
Live 3 to your PA and set the output mode to
Mono.

TC-Helicon VoiceLive 3 Specifications

General

Outputs	XLR, 1/4"
MIDI	In/Out
USB	USB for audio I/O and firmware updates
Inputs	XLR, 1/4"
Power Supply	External power supply (included)