18
7. Reinsert all parts into the
machine in reverse order.
Adjusting the strength of the beverage
(beverage quantity)
Adjust the strength of the beverage to suit your personal taste by adjusting
the quantity of beverage or milk froth. You can do this for one single brewing
or frothing procedure, or you can save the setting.
Adjusting the strength for the current brewing procedure
(without saving the setting)
If the beverage is too weak for your taste, you can stop the water flowm
prematurely by pressing the flashing beverage button.
If the beverage is too strong for your taste, simply restart the brewingm
process without inserting a new capsule. Press the button again as soon
as sufficient water has run through.
Setting the strength of the beverage permanently (saving the setting)
You can change the default settings for the beverage quantities permanently.
You can customise the setting for each beverage button: one setting each for
espresso, caffè crema, black coffee, cappuccino and milk froth.
Espresso, caffè crema and black coffee
1. Proceed as described in the section titled “Making a beverage without milk”:
Fill the water container, insert a capsule and place a cup underneath the
coffee spout.
2. Press and hold the required
button (e.g. caffè crema).
You will hear a beep after
approx. 2 seconds. Release
the button as soon as the
desired quantity has been
dispensed into the cup.
The setting has been saved. If the settings are not to your taste, simply repeat
the procedure to change them again.
Cappuccino
1. Proceed as described in the section titled “Making a beverage without milk”:
Fill the water container and milk container, insert a capsule and place a cup
underneath the coffee and milk spout.
Default settings upon purchasing the machine:
espresso approx. 40 ml I caffè crema approx. 125 ml I black coffee approx. 125 ml
cappuccino approx. 90 ml milk froth, approx. 40 ml espresso
milk froth approx. 130 ml
The water quantity can be set between approx. 30 and 250 ml.
To Next Page
Loading...
