1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with dry cloth.
7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including
amplifiers) that produce heat.
9. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the
point where they exit from the apparatus.
10. WARNING: Please refer the information on exterior bottom enclosure for electrical and safety information
before installing or operating the apparatus.
11. WARNING: The mains plug is used as disconnect device, the disconnect device shall remain readily operable.
12. When not in use and during movement, please take care of the power cord set, e.g. tie up the power cord set
with cable tie or something like that. It shall be free from sharp edges and the like that can cause abrasion of
the power cord set. When put into use again, please make sure the power cord set being not damaged. If any
damages found, please look for the service person to replace the power cord set specified by the manufacturer
or have the same characteristics as the original one.
13. No naked flame sources, such as lighted candles, should be placed on the apparatus.
14. Unplug this apparatus during lightning storms or when unused for long periods of time.
15. Only use attachments/accessories specified by the manufacturer.
16. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus.
When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.
17. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged
in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into
the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been
dropped.
18. For safe operation of the apparatus, observe these installation requirements: Keep at least 2 inches of
ventilation space between the rear cover of the apparatus and the wall. Keep at least 1 inch of ventilation space
between the apparatus and all other surfaces. Do not allow any of the apparatus’ ventilation openings to be
blocked by objects that might obstruct them, such as newspapers, curtains, table-cloths or any other objects. Do
not expose the apparatus to any external heat sources. Do not place any heat sources such as candles, lamps,
etc. on the apparatus. Do not expose the device to high levels of humidity or to any possible sources of
moisture. When disposing of used batteries from the remote control, consult local regulations regarding proper
disposal.
19. If an outside antenna or cable system is connected to the product, be sure the antenna or cable system is
grounded so as to provide some protection against voltage surges and built-up static charges. Section 810 of
the National Electrical Code, ANSI/NFPA No. 70-2011 (Section 54 of Canadian Electrical Code, Part 1)
provides information with respect to proper grounding of the mast and supporting structure, grounding of the
lead in wire to an antenna-discharge unit, size of grounding conductors, location of antenna discharge unit,
connection to grounding electrodes, and requirements for the grounding electrode. See following example:
To Next Page
Loading...
Need help?
General
