FILTERS
Ensure the power is turned off to the unit before attempting to service the filters.
B
C
B A
A. B.
Opening the front panel: at the A recesses, pull the front part up with both hands. The front
panel will stay horizontal (at around 90°).
Closing the front panel: press the front part down at the sides at B and in the middle at. Make
sure it is properly clicks into place.
1. Hold the front panel open (or put it in horizontal position) and remove the filter(s).
2. Use a vacuum cleaner to remove dirt. If the dust filter is very dirty, it may be washed in
lukewarm water with a very small amount of neutral detergent. Rinse well and allow to dry
completely (not in direct sunlight or near a source of heat).
3. Keep the front panel open and reinstall the filter(s). Press the panel shut; a click indicates
it is closed properly.
4. Restore the power from the consumer unit and turn the air conditioner on.
Indoor Unit: While the unit is disconnected from power dust regularly with a dry cloth or slightly
damp paper towel. Never use chemicals or solvents. Never spray a liquid in or over the
appliance.
Exterior unit: While the unit is disconnected from power. Remove dirt and keep the air intake
and exhaust openings free of debris, etc. Cleaning with chemicals may cause damage.
END OF SEASON
If the air conditioner is not going to be used for an extended period:
• Set in fan mode on a slightly warm day so that the inside of the appliance dries out.
• Switch off the power from fuse box and remove the batteries from the remote control.
• Clean filters as well
To Next Page
Loading...
