TCL MS1G

EN - 4
Connect the secondary nodes to the
internet
1. Place each node:
– In a high and open area
– Try to limit the number of walls between nodes to less
than 2, if possible
– Keep nodes away from electronics with strong
interference, such as microwave ovens, inducon
cooktops, and refrigerators
2. Use the other power adapters to connect the remaining
secondary nodes to power sources, with their LED
indicators lit solid green. Wait for about 40 seconds. The
secondary node is connecng to another node when its
indicator blinks green.
3. Observe the LED indicators of the secondary nodes unl
their LED indicators light one of the following colors:
Solid green: Good connecon
Solid yellow: Fair connecon
Solid red: Disconnected
4. If a node’s LED does not light solid green, relocate it
according to placement ps to get it beer connected.
• To access the Internet:
– Wired devices: Connect wired devices to the LAN ports
of your nodes.
– Wireless devices: Connect wireless devices to your WiFi
network using the SSID and WiFi password you set.
• If you want to manage the network anyme anywhere, tap
and use your account to login.
LED Indicator
– The LED will ash green slowly when the node is waing
to connect
– The LED will ash green fast while the node is connecng
– The LED will be solid green when the node is connected
– The LED will ash fast when you reset the node