20 21
WPS
Wi-Fi Protected Setup (WPS) is a wireless network security standard that tries to make
connections between your LINKZONE and wireless devices faster and easier. It enables
compatible devices to connect to a wireless network without entering the password.
If your wireless device is WPS-supported, you can access the LINKZONE Wi-Fi network
through a WPS connection.
To make a WPS connection:
1. Log in to the web UI of your LINKZONE, and go to Wi-Fi > WPS. (For how to log in to
the web UI, see "Chapter 5. Accessing the Admin Web UI" on page 16.)
2. Click Start WPS.
3. Enable the WPS function of your wireless device within 2 minutes to make a WPS
connection.
When a WPS connection is established, the WPS icon will show on the upper right corner
of the status bar. If the connection fails to be established, enter the Wi-Fi password
manually.
NOTE: WPS will be disabled if W-Fi security is set to WPA3, Disabled or encryption is
set to AES, or SSID broadcast is turned off.
6.3 Data Usage
Click > to go to Data Usage page to view the current data usage. This section displays
the amount of data used and your monthly billing plan.
6.4 Connected Devices
This tab allows you to edit the connected device name, and manage internet access
for connected devices. You can also block or unblock devices from the list of available
devices.
6.5 Messages
This tab allows you to view your messages. Messages can not be sent or forwarded from
the Mobile Hotspot. Use another mobile device to send messages.
Refer to the following table for the description of each folder under the Messages tab.
Messages
Incoming messages are stored in this folder.
NOTE: Inbox messages does not display if the SIM card is not
properly installed.
Refer to the following table for commonly used operations of SMS messages.
Read a message Click the message you want to read.
Delete a message
1. Locate the message you want to delete in the
Messages folder.
2. Tick the checkbox beside the message you want to
delete.
3. Click Delete.
Delete all messages
1. Click at the top of the checkbox column to select all
messages.
2. Click Delete.
6.6 Mobile Network
This tab allows you to prioritize the network connection, configure profile management,
and more.
Network Connection
In this option, you can configure and manage mobile data, and data roaming. Connection
mode is set to Auto and cannot be edited.
Profile management
In this option, you can edit the APN profile. Make sure you click Apply after making
desired changes.
Network Settings
You can set the network search mode and change the network search mode.
Make sure you click Apply after making desired changes.
SIM PIN Management
If the SIM card is locked, click "Unlock the SIM card" to enter the SIM PIN Management
page. (or navigate to Mobile Network > SIM PIN Management from the side bar.) You
must enter the PIN before connecting to the network.
Refer to the following table to enable, disable or change SIM PIN code.
Enable SIM PIN
1. When the SIM PIN feature is disabled, click
.
2. Set a SIM PIN code.
3. Click Apply.
Disable SIM PIN
1. When the SIM PIN feature is enabled, click
.
2. Enter the current SIM PIN code.
3. Click Apply.
To Next Page
Loading...
Need help?
General
