ZK300DC SWING GATE OPERATOR USER’S MANUAL
16
11. Maintenance
Regularly verify that the gate swings freely.
Make sure the hinges function perfectly.
Verify correct operation of the safety devices.
Keep operator clean at all times.
12. Troubleshooting
Table 3
Motor runs, but gate
does not open or
close.
1.The gate is obstructed.
2.The operator is released.
3.The gate is obstructed.
1. Remove obstructions.
2. Engage the operator.
3. remote the obstructions.
Gate does not open
far enough or does
not have the proper
opening angle.
The gate operator is not
installed properly according to
Fig.4 in the gate geometry
section of this manual.
Either modify the
installation to meet Fig.4 or
adjust the size or replace
the installation brackets in
accordance with the gate
geometry section of this
manual.
1.Power supply.
2.The fuse in the control box is
broken.
1. Check the power.
2. Change the fuse.
Remote control does
not work.
1. The indicator light of
remote control does not light.
2. Remote control is broken.
3. The operating distance is
too far away.
1. Check the batteries in
your remote control.
2. Change the remote
control.
3. Make sure the operating
range is less than 30m.
To Previous Page
Loading...