To Next Page

TREK Micro Battery Replacement Instructions

Caution: Disconnect the micro USB power connection and place the power switch on

the right side of the unit in the OFF position before beginning the replacement.

1. Using a 1.5 mm. hex wrench, remove the four

screws holding the bottom plate.

2. With a tweezers or needle nosed pliers,

carefully lift the bottom plate.

3. Lift the cable and connector.

Other manuals for TDK TREK Micro

Questions and Answers:

Need help?

Do you have a question about the TDK TREK Micro and is the answer not in the manual?

General