TDK TREK 360 - User Manual

TREK 360 Battery Replacement Instructions
Caution: Disconnect the TREK 360 power and place the power switch on the rear
of the unit in the OFF position before beginning the replacement.
1. Place the unit on its left side. Using a
T-5 Torx driver, remove the four screws
holding the battery cover plate.
2. Place the unit upright. With a
jeweler’s screwdriver or a tweezers,
carefully pry out the battery cover
plate.
3. The battery compartment.

Summary

TREK 360 Battery Replacement Guide

Safety and Preparation Steps

Disconnect power, turn off unit, and position for access before starting.

Accessing the Battery Compartment

Remove screws holding the battery cover plate and carefully pry it open.

Removing the Old Battery

Loosen the battery assembly, lift it out, and unplug the battery connector.

Installing the New Battery

Insert the replacement battery and reconnect the power cable.

Securing the Battery Cover

Replace the battery cover and reinstall the four retaining screws.

Environmental Battery Disposal

Follow local regulations for proper disposal; do not incinerate batteries.

TDK TREK 360 Specifications

General

Brand	TDK
Model	TREK 360
Category	Speakers
Language	English