Teac A-4070G - Page 4

3 EQUIPMENT REQUIRED
FOR
MECHANICAL
MEASUREMENT
————————__________
eee
SPRING SCALE:
TEST TAPE:
FLUTTER METER:
DIGITAL FREQ. COUNTER:
TOOLS:
0.4 kilo-grams (08 lbs) #5086025000
0.300 grams (0°10 oz) #5086026000
TEAC YTT-2003 (7-1/2ips)
TEAC YTT-2002 (3-3/4ips)
Meguro Model MK665B (preferred) or
Sentinel FL-3D-1
Capable of O to 5kHz indication
General,
2mm nut driver #5086014000
Hex head, allen wrench #5086021000
TEAC TEST TAPE
Fig. 3-l Spring Scale, and TEAC Test Tape
FOR ELECTRICAL MEASUREMENT
TEST TAPE:
EMPTY REEL:
TEST SET:
BAND PASS FILTER:
AC/DC VIVM:
RESISTOR:
OSCILLOSCOPE:
Fig. 3-2 TEAC M-826A
TEAC YTT-1003 for 7-1/2ips
TEAC YTT-1002 for 3-3/4ips
SCOTCH 203 and 150 for test recording
TEAC RE~702 (2" hub)
TEAC RE-701 (4" hub)
TEAC M~826A test set
TEAC M-206A (1kHz)
General purpose
Non inductive type 82/1W
General purpose
NOTE
Use of the TEAC M-826A test set is rec-
ommended. This set incorporates an AC
VTIVM, Audio Oscillator, Channel Select~
ing switch, Variable Attenuator, Monzitor
Speaker and Cables.
TEAC M-826A measures the RMS value of
the Voltage (OdB=0.775V). Characteristics
of this test set are similar to the stan-
dard VU-meter.