Teac A-4070G - Front Panel Removal; Assembly Access

FRONT PANEL REMOVAL
I
ul & WN
6.
7.
Place the A-4070G on its back, with the front panel assy face up
and the bottom of the deck towards you.
Remove the head housing assy.
Remove both tape tension arms.
Remove knobs.
Remove the ten (10) cross-point screws from the front panels.
NOTE
Two screws are immediately above the tape head mechanism.
Lift off the control panel assy.
Lift off the front panel assy.
AMPLIFIER ASSEMBLY ACCESS
The A-4070G is equipped with a removable amplifier assembly. By
removing the six screws that secure the amplifier to the bottom of
the chassis, you can easily swing out the amplifier for maintenance.
Most of the replacement components are completely accessible. If
amplifier assy maintenance is necessary, follow these steps:
1.
2.
AMPLIFIER ASSEMBLY ACCESS
Complete all steps in front panel removal.
Remove six (6) cross-point screws from the sides of the bottom
panel.
NOTE
Three lower screws are holding the cover panel over the
PC boards. These need not be removed. Access slots are
provided.
Grasp the control shafts and gently swing the amplifier assy dow
towards you. Two screws on the lower sides act as a hinge for the
assy.
To re-~assemble, reverse the above procedure.
CAUTION
When closing the amplifier assy, closely observe the wires
leading to the right-channel VU meter lamp socket.