What to do if the VU meter is inoperative in both modes on my Teac A-6100?
If the VU meter is inoperative in both modes, the cause may be a faulty meter or wiring. Replace the faulty meter or wiring.
What causes excessive wow and flutter on my Teac A-6100 Tape Deck?
Excessive wow and flutter can be caused by improper pinch roller pressure, an oily or defective belt, or back tension that is too high. Try these solutions: 1. Adjust the pinch roller pressure. 2. Replace or clean the belt. 3. Adjust the back tension.
What causes the pinch roller to fail to engage completely on my Teac A-6100 Tape Deck?
If the pinch roller fails to engage completely, the cause may be a faulty solenoid, or defective components such as K4, Dl4, Dl8 (A-6100) or K2 (A-6300) or associated parts. Replace the faulty solenoid or the defective components.
General| Type | Reel-to-reel tape deck |
|---|---|
| Track Configuration | 4-track, 2-channel stereo |
| Heads | 3 (Erase, Record, Playback) |
| Signal-to-Noise Ratio | 50 dB |
| Tape Speed | 3.75 & 7.5 ips |
| Reel Size | 10.5 inches |
| Wow and Flutter | 0.08% at 7 1⁄2 ips |
| Inputs | Line |
| Outputs | Line (RCA) |
Detailed electrical specifications for the TEAC A-6100 stereo tape deck.
Detailed electrical specifications for the TEAC A-6300 stereo tape deck.
Details mechanical specifications for the TEAC A-6100 tape deck, including motors and reel size.
Details mechanical specifications for the TEAC A-6300 tape deck, including motors and reel size.
Procedure for adjusting the height of record and playback heads for optimal tape contact.
Method for measuring and adjusting pinch roller pressure using a spring scale.
Procedure for measuring and adjusting brake torque on reel motors.
Diagram showing adjustment points for the A-6300 PC board.
Procedure for checking and adjusting the power supply voltage at VR-1.
Steps for adjusting playback head azimuth for the A-6300.
Procedure to set the specified output level for the A-6300.
Method to calibrate the VU meter for the A-6300.
Method to check and adjust frequency response for 2-track and 4-track playback.
Procedure for checking and adjusting frequency response for A-6300.
Instructions for adjusting bias traps on the A-6300.
Procedure for adjusting bias for recording on the A-6300.
Steps for adjusting record head azimuth on the A-6300.
Procedure for setting the record level on the A-6300.
Method for adjusting record frequency response on the A-6300.
Procedure to measure erase efficiency for the A-6300.
Lists common mechanical malfunctions and their potential causes and solutions.
Lists common electrical malfunctions and their potential causes and solutions.
To Next Page
