Teac AG-V4200 - Batteries; Cautions on Use of the Remote Control Unit

REMOTE CONTROL UNIT
By using the provided remote control unit, the receiver
and some other TEAC components used with it can be
controlled from your listening position.
Remote control of other TEAC components using the
UR-407 is explained later, on page 21.
1. Remove the battery compartment cover.
2. Insert two "AA" (R6, SUM-3) dry batteries.
Make sure that the batteries are inserted-with their
positive (+) and negative (-) poles positioned correctly.
3. Close the cover until it clicks.
Using the Remote Control Unit
To use the UR-407, point it at the REMOTE SENSOR
window of the receiver (or other TEAC component)
within the range shown.
|
REMOTE SENSOR window
of the receiver or other
TEAC component
Approx.
7m
Cautions on Use of the Remote
Control Unit
Battery Replacement Period
If the operation range from the unit to the receiver
begins to decrease, the batteries are nearly exhausted
and both should be replaced.
Precautions Concerning Batteries
e Be sure to insert the batteries correctly, as shown in
the battery compartment.
@ Do not use old and new batteries together.
e Use batteries of the same type. Never use batteries
of different types together, even if they are the
same shape.
e Both rechargeable and non-rechargeable batteries
can be used. Refer to the cautions on their labels
before use.
© Do not disassemble batteries and never dispose of
old batteries by throwing them in a fire as they
could explode.
— {2—
e@ Even within the range shown, if there is any
obstacle between the remote control unit and the
receiver, operation will be impaired.
© If you have other appliances controlled by infrared
signals installed in the same room as your AG-
4200, these could be operated erroneously due to
signals from the remote control. (TEAC cannot take
responsibility for any incidental or consequential
damage this may cause.) Conversely, their remote
controls could cause the AG-V4200 to operate
erroneously.
@ Placing objects on top of the remote control unit
may inadvertently depress buttons and exhaust the
batteries.
© If the remote control unit is not to be used for more
than a month or so, remove the batteries to avoid
damage caused by leakage.
If batteries do leak, clean the battery compartment
by wiping with a clean tissue and insert new
batteries.