Teac CX-200iDAB - Setting the Timer

32
Press the SKIP button (.//) to set the start time
(minute), and then press the TIMER button.
3
‘TimerOff’ appears on the display and the ‘hour’ value starts
flashing.
Press the SKIP button (.//) to set the stop time
(minute), and then press the TIMER button.
5
The ‘minutes’ value starts flashing.
Press the SKIP button (.//) to set the stop time
(hour), and then press the TIMER button.
4
Setting the Timer
< The unit can be programmed to turn on and off at a specified
time.
< Adjust the clock before setting the timer.
Press and hold the TIMER button until ‘TimerOn’
appears on the display.
1
The ‘hour’ value starts flashing.
< When no button is pressed for 10 seconds, the timer setting
mode will be cancelled.
The ‘minutes’ value starts flashing.
Press the SKIP button (.//) to set the start time
(hour), and then press the TIMER button.
2
TIMER
/
STANDBY/ON