Teac LT-1 - Clock and Timer Functions; Clock Adjustment

16
Clock Adjustment
Press the DISPLAY button to select clock display.
":" blinks in the clock display.
<
If the unit is off, press and hold the MEMORY/CLOCK
ADJUST button for 2 or more seconds, and continue
the procedure from step .
<
Press the STOP button to cancel the time setting. (In
the TUNER mode, press the DISPLAY button.)
Within 4 seconds, press and hold the
MEMORY/CLOCK ADJUST button for 2 or more
seconds.
Press the .m
or ,/ button to select
"12H" or "24H".
If you select "12H", "AM" or "PM" appears on the
display.
<
In the TUNER mode, use the TUNING knob.
Press the MEMORY/CLOCK ADJUST button.
4
3
2
3
1
Press the .mor,/ button to set the
current hour.
<
In the TUNER mode, use the TUNING knob.
Press the MEMORY/CLOCK ADJUST button.
Press the .m
or,/ button to set the
current minute.
<
In the TUNER mode, use the TUNING knob.
Press the MEMORY/CLOCK ADJUST button to finish
the time setting mode.
The clock starts from 00 second.
<
If the unit is disconnected from the power supply for
more than 3 minutes, the clock and timer setting will
be reset.
<
If the unit is disconnected for less than 3 minutes
the time displayed may not be correct.
8
7
6
5
MEMORY/CLOCK ADJDISPLAY
.m,/