Teac NT-503 - Connecting headphones; Headphone Jack Usage; Upconversion; Upconversion Functionality

EN
11
You can use the upconversion function with all input sources (page
21).
The relationships between input sampling frequencies and sam-
pling frequencies after upconversion are as follows.
Input source Upconversion setting
Digital
audio input
USB OFF 2Fs 4Fs 8Fs DSD
Input sampling
frequency
Sampling frequency after upconversion
[kHz] [kHz] [MHz]
32 – 32 64 128 256 8.0
44.1 44.1 44.1 88.2 176.4 352.8 11.2
88.2 88.2 88.2 88.2 176.4 352.8 11.2
176.4 176.4 176.4 176.4 176.4 352.8 11.2
– 352.8 352.8 352.8 352.8 352.8 11.2
48 48 48 96 192 384 12.2
96 96 96 96 192 384 12.2
192 192 192 192 192 384 12.2
– 384 384 384 384 384 12.2
Values indicated by are unchanged.
Connecting headphones
V
CAUTION
While wearing headphones, do not connect or disconnect them or
turn the unit on or off.
Doing so could result in a sudden loud noise that could harm your
hearing.
Always set the volume to minimum (−∞ dB) before putting head-
phones on (page 15).
Upconversion